How the calculator works
It builds the real QR code for your content and error correction level, counts its modules, then applies four checks and uses whichever needs the largest size:
- The 10:1 rule. A typical code scans from about ten times its width.
- Density. The 10:1 rule assumes a code of about 41 modules including its border. Denser codes scale up in proportion, so every module stays big enough for the camera.
- A 2 cm floor. Below that, codes get unreliable even when scanned up close.
- A 0.4 mm module minimum so print processes can reproduce each dot.
The conditions setting adds 25% or 50% for dim light, angles, gloss and curves. These are rules of thumb, not a standard: always scan a printed proof before a big run. More on sizing in how small can a QR code be?
Make it smaller without hurting scans
- Shorten the content. A short link on your own domain can halve the number of modules.
- Use error correction M instead of H when there's no logo and the surface is clean.
- Keep the quiet zone at 4 modules; cutting it saves little and costs reliability.